Usb Reactor

USB reactor is essentially a suspended-growth reactor, but it is also a fixed-biomass process. Part B in Figure 7.28.2 shows the process schematic. This USB system is based on the development of a sludge blanket. In this sludge blanket, the component particles are aggregated to withstand the hydraulic shear of the upwardly flowing wastewater without being carried upwards and out of the reactor. The sludge flocs must be structurally stable so that hydraulic shear forces do not break them into smaller portions that can be washed out, and they should also have good settlement properties.

The wastewater is fed at the bottom of the reactor, and active anaerobic sludge solids convert the organics into methane and carbon dioxide. The anaerobic biomass is distributed over the sludge blanket and a granular sludge bed. The sludge solids concentration in the sludge bed is high—100,000 mg/l SS—and does not vary over a range of process conditions (Shieh and Li 1987). The sludge solids concentration in the sludge blanket is lower and depends on process conditions (Li 1984). The reactor can include an internal baffle system, usually referred to as a gas-liquid separator, above the sludge blanket to separate the biogas, sludge, and liquid. A patented USB reactor called the BIOTHANE process was developed by the Biothane Corporation in the United States.

Project Earth Conservation

Project Earth Conservation

Get All The Support And Guidance You Need To Be A Success At Helping Save The Earth. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Recycle to Create a Better Future for Our Children.

Get My Free Ebook


Post a comment