Solid Bowl Conveyor Centrifuge

A conveyor centrifuge is used when the SS are coarse, high concentration cakes are required, solids loading is high, or classified solids recovery is required. The unit is flexible, easy to operate over a range of feed rates and concentrations, and requires little attention. The combination cylindrical-conical bowl ranges from a 6-in diameter for testing to 14 to 36 in for commercial units. Long bowls at more than a 4-to-1 length-to-diameter ratio have higher capacities and are commonly applied on waste sludge at 1000 to 2700 G acceleration.

The rotating assembly of a conveyor centrifuge consists of a bowl shell and a conveyor supported between two sets of bearings. This bowl and conveyor are linked through a planetary gear system designed to rotate the bowl and conveyor at slightly different speeds. The bowls are belt-driven. The rotating assembly is covered by a stationary casing for safety, odor, and noise control.

In the usual countercurrent design (see Part A in Figure 7.48.5), the feed enters through a pipe in the hollow shaft of the conveyor, accelerates through ports, and enters the annular pond of liquid at the wall of the bowl close to the conical section. Liquid flows to the far end of the bowl and discharges as clarified effluent (centrate) over adjustable weirs that regulate the depth of the pond. The conveyor moves the settled solids to the conical section where they drain on the unsubmerged beach before discharge.

In the cocurrent design (see Part B in Figure 7.48.5), the feed is introduced at the end of the bowl. The liquid and settled solids move together toward the conical beach. An adjustable skimmer removes the supernatant liquid, while the solids drain on the beach before discharge.

The abrasive nature of waste sludges ranges from extremely abrasive pulp mill waste to clean biological sludge. Paper mill and primary sewage sludges have necessitated

FIG. 7.48.5 Solid bowl conveyor centrifuge. A, Counter-current; B, Cocurrent.

the use of abrasion-resistant, hard-surfacing materials for direct application or as replaceable inserts.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment