Mixing And Agitation

The two types of mixing that are important to the control system are intermixing and backmixing. The reagent must be intermixed with the process stream to furnish complete elimination of the areas of unreacted reagent or untreated influent. Adequate intermixing between influent and reagent can be readily achieved by adding the reagent at a point of small cross-sectional area where there is some turbulence. Figure 7.40.12 illustrates the reagent being added in the pipeline before the influent enters the treatment facility. This is a desirable practice because it eliminates poor intermixing, which can cause a noisy signal to be observed in the effluent pH. A loop seal arrangement, particularly when long reagent transfer lines are required, allows the reagent line to remain full up to the point of introduction to the process and thus eliminates a potential source of process dead time.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment