Lines Of Magnetic Induction

FIG. 7.6.4 The probe-type magnetic flowmeter.

Magnetic flowmeters are not affected by viscosity or consistency (referring to Newtonian and nonNewtonian fluids, respectively). Changes in the flow profile due to changes in Reynolds numbers or upstream piping do not greatly affect the performance of magnetic flowmeters. The voltage generated is the sum of the incremental voltages across the entire area between the electrodes, resulting in a measure of the average fluid velocity. Nevertheless, the meter should be installed with five diameters of straight pipe before and three diameters of straight pipe following the meter.

Magnetic flowmeters are bidirectional. Manufacturers offer converters with output signals for both direct and reverse flows.

The magnetic flowmeter must be full to assume accurate measurement. If the pipe is only partially full, the electrode voltage, which is proportional to the fluid velocity, is still multiplied with the full cross section, and the reading will be high. Similarly, if the liquid contains entrained gases, the meter measures them as liquid, the reading will be high.

The meter's electrodes must remain in electrical contact with the fluid being measured and should be installed in the horizontal plane. In applications where a buildup or coating occurs on the inside wall of the flowmeter, periodic flushing or cleaning is recommended.

Special meters for measuring sewage sludge flow are designed to prevent the buildup and carbonizing of sludge on the meter electrodes. They use self-heating to elevate the metering body temperature to prevent sludge and grease accumulation.

Project Earth Conservation

Project Earth Conservation

Get All The Support And Guidance You Need To Be A Success At Helping Save The Earth. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Recycle to Create a Better Future for Our Children.

Get My Free Ebook


Post a comment