Filtration Enhanced By Applied Chemical Coagulants

Wastewater treatment facilities can obtain completely clear filter effluents only by feeding chemical coagulants, such as alum, iron, or polyelectrolytes, to the wastewater prior to filtration. Adding chemicals to clarifiers reduces the solids load on the clarifier overflow effluent filters.

When a facility is considering adding chemicals into the filter influent, they should perform coagulation tests or pilot-filtration tests. Chemical coagulation can result in 100% solids removal including colloidal particle sizes as small as 0.05 /. When stain-free filter effluent is required, chemical feeds are absolutely necessary. Without chemical feeds, the SS removal efficiency of filters generally ranges from 50 to 80%.

However, adding chemical coagulants increases the solids load; therefore, filter runs are shortened. Surface-type and ultra-high-rate filters are drastically affected in this regard. Adding coagulants can be costly not only because of shortened runs, but also because of the cost of chemicals, pumping, and labor.

In multilayered or in-depth filter applications, the influent must contain flocculant particles ranging from 1/32 to 1/4 in, whether these particles are natural particles, biological flocs, or freshly coagulated flocs. The larger flocs are removed by the coarse filter layers, and the smaller particles are removed by the fine sand layers below. If only smaller flocs are present, they are deposited primarily in the fine lower layers, resulting in a solids removal capacity no better than that of single-layer filters.

Project Earth Conservation

Project Earth Conservation

Get All The Support And Guidance You Need To Be A Success At Helping Save The Earth. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Recycle to Create a Better Future for Our Children.

Get My Free Ebook


Post a comment