Control Method Selection

In the design of chlorinators, environmental engineers must also select the control system. The simplest control system is a manual rate of feed control. Almost as simple is a control system with an intermittent start and stop feature. This method is unsatisfactory unless the stream being treated has a constant flow rate when started (such as from a pump).

When the flow varies, as it usually does through a sewage plant, chlorinator feed should be proportionate. A ratio controller can measure the effluent flow rate, to furnish automatic modulation of chlorinator feed rate.

If the average flow is 1,200,000 gpd or 50,000 gph, the hourly peak flow can be twice that, while the minimum flow at four o'clock in the morning can easily be one-tenth that amount. Therefore, a chlorinator with an adjustable feed rate of 8 to 160 lb of chlorine per day throttled by an automatic flow ratio controller is needed.

A more complete control system includes a continuously recording, residual-chlorine analyzer installed downstream from the chlorination unit. If the residual chlorine level drops below the standard, the analyzer controller adjusts the chlorine flow upward. The wastewater treatment facility can vary the rate of feed (see the rate valve opening on Figure 7.30.10) to compensate for changes in the flow through the plant and adjust the dosage (see the control signal port on Figure 7.30.10) to compensate for changes in effluent chlorine demand.

FIG. 7.30.11 Maximum chlorine feed rates at various temperatures for 100- or 150-lb cylinders (can be exceeded for short periods).
Project Earth Conservation

Project Earth Conservation

Get All The Support And Guidance You Need To Be A Success At Helping Save The Earth. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Recycle to Create a Better Future for Our Children.

Get My Free Ebook


Post a comment