Advantages And Disadvantages

Compared to other composition-measuring techniques, such as photometric, titrimetric, chromotographic, or automated-classic analysis, ion-selective electrode measurement has several advantages. Electrode measurement is simple, rapid, nondestructive, direct, and continuous. Therefore, it is easily applied to closed-loop process control. In this respect, it is similar to using a thermocouple for temperature control. Electrodes can also be used in opaque solutions and viscous slurries. In addition, the elec trodes measure the free or active-ionic species under process conditions and the status of a process reaction.

However, several disadvantages exist. The specificity of ion-selective electrodes is not as good as that of the glass pH electrode. Interferences vary from minor to major; environmental engineers must consult publications and manufacturers' data on limitations for each electrode. Also, the electrodes do not measure total ion concentration, although this parameter is often requested. Prior to the introduction of electrodes, concentration information was the only information available from the chemists' classic measurement techniques. Control laboratory chemists and process engineers do not think in terms of activity, even when making pH measurements. This habit may disappear as the ion-selective technique becomes more popular.

Sometimes concentration is a beneficial measurement, for example, in material-balance calculations or pollution control. Knowledge of material balance allows engineers to predict where a process reaction will occur. This information is necessary if a process is to be controlled by introducing changes that nullify those predicted.

In pollution control, environmental engineers believe that many ions, even in the combined state, are detrimental to life forms. For example, fluorides, cyanides, and sulfides are deleterious to fish and humans in many combined forms. However, they are not detected by ion-selective electrodes in the combined state. Consequently, pollution control agencies usually require concentration information. Electrodes can be used for concentration measurement if they are calibrated with solutions matching the process or ISAB solutions. If these measurements are not satisfactory, environmental engineers can use an electrode for online control and analyze separate grab samples by other procedures to obtain the information needed to comply with regulations.

Another disadvantage derives from a misunderstanding about precision and accuracy. Many classic analytical techniques name a relative error of ±0.1%. Ion-selective electrodes name relative errors of ±4 to 8%. In terms of pH, this amount is equivalent to a measurement of ±0.02 pH units—ordinarily a satisfactory measurement. When used with understanding, ion-selective electrodes can supply satisfactory composition information and afford closed-loop control that was previously unattainable. When in doubt, environmental engineers should consult with electrode manufacturers or analytical chemists.

Project Earth Conservation

Project Earth Conservation

Get All The Support And Guidance You Need To Be A Success At Helping Save The Earth. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Recycle to Create a Better Future for Our Children.

Get My Free Ebook

Post a comment