Activated And Digested Sludge

Derived solid sludge from anaerobic digestion of settled raw sludge is readily dewaterable by filtration. The SS concentration in the digester product is lower (4.6 to 6.7% VSS) than that in the feed because of the anaerobic conversion of some organic material to methane. This sludge can be successfully filtered on coil-type RDVFs (see Figure 7.47.2).

Sludge from secondary treatment (activated-sludge process) consists of bacteria, dead cells, and associated material formed under oxidizing conditions. Suspended bacterial solids in the aeration tank are usually in the range of 2500 to 4000 mg/l. These solids can be removed on a deep-bed filter (see Figure 7.47.3) which can take the full flow of the plant.

Ordinarily, however, the aeration tank suspension is continuously circulated to a clarifier, whose underflow (bottom discharge sludge) contains 1 to 3% dry solids concentration or higher by weight depending on the settling time and properties. When excess activated sludge is conditioned with ferric chloride (10 lb per 100 lb dry solids), filtration usually proceeds well on vacuum belt filters at solids rates of 1 to 4 lb/hr/ft2, or filtrate rates of 15 to 40 gph/ft2 (see Table 7.47.3). Figure 7.47.4 shows the special cake discharge methods.

Activated sludge does not filter as well as digested primary sludge as on the coil filter. The latter contains enough fibrous material to bridge the openings in the coils, whereas activated sludge does not.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment