4

H+1.5L1

H+0.5L2

Schulman-Scire Applies

Area of influence:

nd I

5L Downwind 2L Upwind 0.5L Crosswind

5L In all directions -

H = Height of building L = Lesser of height or width of building

1Compare H+1.5L to plume elevation (stack height above grade + momentum plume rise 2L

downwind-stack-tip downwash)

2Compare H+.5L to physical stack height above grade

FIG. 5.8.13 Selection of downwash algorithms in the ISCST model. (Reprinted, with permission, from Trinity Consultants, Inc., 1989, Atmospheric diffusion notes, Issue no. 13, Dallas, Tex. [June].)

proach is called the good engineering practice (GEP) of stack height design (U.S. EPA 1985) and retroactively covers all stacks built since December 31, 1970. The following equation determines the GEP stack height:

where:

Hgep = the GEP stack height

H = the maximum height of an adjacent or nearby structure

L = the lesser dimension of the height or projected width of an adjacent or nearby structure

The projected width of a structure is the exposed area perpendicular to the wind as shown in Figure 5.8.14. Environmental engineers should check all structures within 5L of the stack for their possible effect on the plume. The range of influence for a given structure is defined by Tickvart (1988) as 2L upwind of the structure, 5L downwind, and 0.5L on the sides parallel to the wind flow.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment