Info

a If the length of the slot is less than the maximum shown in Table 4.10, the value shown may be reduced by one-half the difference between the maximum and the actual slot lengths. Note: 1 in. = 25.4 mm.

a If the length of the slot is less than the maximum shown in Table 4.10, the value shown may be reduced by one-half the difference between the maximum and the actual slot lengths. Note: 1 in. = 25.4 mm.

For unpainted members of weathering steel subject to atmospheric corrosion: smaller of 14t where t is the thickness of the thinner plate and 7 in. (178 mm).

4.11.1.8 Maximum Edge Distance

A limit is placed on the maximum value for edge distance to prevent prying action from occurring. The maximum edge distance shall not exceed the smaller of 121 where t is the thickness of the connected part and 6 in. (15 cm).

0 0

Post a comment