References cited in this section

1. P.C. Mathur, D. Apelian, and A. Lawley, Analysis of Spray Deposition, Acta Metall., Vol 37, 1989, p 429

3. C. Cai, S. Annavarapu, and R.D. Doherty, Modeling-Based Microstructural Control in Spray Forming, Proc. of the Second Int. Conf. on Spray Forming, ICSF II (Swansea, U.K.), J.V. Wood, Ed., Woodhead Publishing, Cambridge, U.K., 1993, p 67

15. G.M. Trapaga, E.F. Matthys, J.J. Valencia, and J. Szekely, Fluid Flow, Heat Transfer and Solidification of Molten Metal Droplets Impinging on Substrates: Comparison of Numerical and Experimental Results, Metall. Trans. B, Vol 23, 1992, p 701

27. C. Cai, "A Modeling Study for Design and Control of Spray Forming," Ph.D. dissertation, Department of Materials Engineering, Drexel University, 1995

29. R.D. Doherty, "Modeling for Microstructural Control," Final Report N00014-89-J-P0001, Office of Naval Research, Arlington, VA, 1996

34. M. Gundoz and J.D. Hunt, The Measurement of the Solid-Liquid Interfacial Energies in the Al-Cu, Al-Si, and Pb-Sn Systems, Acta Metall., Vol 33, 1985, p 1641

47. K. Bauckhage, H.H. Floegel, U. Fritsching, and R. Hiller, The Phase-Doppler-Difference-Method: A New Laser-Doppler Technique for Simultaneous Size and Velocity Measurements, Particle Charac., Vol 5,

48. B. Bewley and B. Cantor, Modeling of Spray Deposition: Measurements of Particle Size, Gas Velocity, Particle Velocity, and Spray Temperature in Gas Atomized Sprays, Metall. Trans. B, Vol 21, 1990, p 899

0 0

Post a comment