Info

Drawn Tube

Source: Aluminum Association [2].

*Ftu and Fty are minimum specified values (except Fty for 1100-H12, -H14 Cold Finished Rod and Bar and Drawn Tube, Alclad 3003-H18 Sheet and 5050-H32, -H34 Cold Finished Rod and Bar which are minimum expected values); other strength properties are corresponding minimum expected values.

^Typical values. For deflection calculations an average modulus of elasticity is used; this is 700 MPa lower than values in this column.

Drawn Tube

Source: Aluminum Association [2].

*Ftu and Fty are minimum specified values (except Fty for 1100-H12, -H14 Cold Finished Rod and Bar and Drawn Tube, Alclad 3003-H18 Sheet and 5050-H32, -H34 Cold Finished Rod and Bar which are minimum expected values); other strength properties are corresponding minimum expected values.

^Typical values. For deflection calculations an average modulus of elasticity is used; this is 700 MPa lower than values in this column.

TABLE 9.16A Mechanical Property Limits for Commonly Used Aluminum Sand Casting Alloys®
0 0

Post a comment