14

1G,1GG

Source: Aluminum Association [2].

* Fu and Fy are minimum specified values (except Fy for 1100-H12, -H14 Cold Finished Rod and Bar and Drawn Tube, Alclad 3003-H18 Sheet and 5050-H32, -H34 Cold Finished Rod and Bar which are minimum expected values); other strength properties are corresponding minimum expected values.

^Typical values. For deflection calculations an average modulus of elasticity is used; this is 100 ksi lower than values in this column.

Source: Aluminum Association [2].

* Fu and Fy are minimum specified values (except Fy for 1100-H12, -H14 Cold Finished Rod and Bar and Drawn Tube, Alclad 3003-H18 Sheet and 5050-H32, -H34 Cold Finished Rod and Bar which are minimum expected values); other strength properties are corresponding minimum expected values.

^Typical values. For deflection calculations an average modulus of elasticity is used; this is 100 ksi lower than values in this column.

TABLE 9.15B Minimum Mechanical Properties for Aluminum Alloys (SI)
0 0

Post a comment